SkyView System Installation Guide - Dynon Avionics

Basic SkyView Display OperationFlight Angle Pitch Adjust–This page allows you to adjust the displayed pitch of the plane.Airspeed Limitations–Enter this menu to configure the V-speeds and specify optimalflight parameters such as best angle of climb speed, best rate of climb speed, andmaneuvering speed.Vertical Speed Scale–Enter this page to configure the vertical speed tape's scale.G Meter–Enter this page to configure G values that will cause the G Meter to beautomatically displayed when exceeded; to set the yellow/red cautionary color rangesof the G meter; and whether or not the max/min recorded Gs are reset at each SkyViewboot-up.Flight Path Marker–Enter this page to enable/disable display of the flight path marker.Extreme Pitch Warning–Enter this page to enable/disable display of the extreme pitchwarning indicators.Angle of Attack–Enter this page to enable/disable display of the Angle of Attackindicator.Altitude Alerter–Enter this page to configure the altitude alerter.o CAPTURE BAND: When the altitude of the aircraft flies within this amount offeet/meters of the altitude bug (when displayed), SkyView will announce“approaching altitude” aurally (if audio output is configured)o DEVIATION BAND: When the altitude of the aircraft climbs above or descendsbelow the altitude bug by the amount of feet or meters set here, SkyView willannounce “departing altitude” aurally (if audio output is configured).EMS Setup MenuThis menu contains links to the following wizards and menu:Engine Information–Enter this wizard to record important information regarding theengine in your aircraft such as engine type and horsepower. The user-enteredinformation here is used to calculate quantities such as % power and special operatinglimitations.Sensor Input Mapping...–Enter this wizard to map engine and environmental sensors toSV-EMS-220/221 pins. Reference the EMS Sensor Input Mapping Section of this guidefor instructions on how to navigate and use this menu to map sensors.Screen Layout Editor–Enter this wizard to configure the placement and style of theonscreen EMS gauges on EMS pages. Reference the EMS Screen Layout Editor Section ofthis guide for instructions on how to use this wizard.Sensor Setup–Enter this menu to configure the graphical display properties of mappedsensors. Reference the EMS Sensor Setting Section of this guide for more informationregarding sensor setup.MAP Setup MenuThis menu contains links to the following wizards and menus:Terrain Warning Colors – Sets whether red and yellow terrain warning are provided onthe Map Page3-12 SkyView System Installation Guide - Revision O