SkyView System Installation Guide - Dynon Avionics

Revision Revision Date DescriptionAdded information in applicable locations regarding the SV-NET-SERVO wiring kit.Color-coded the connectors in the example SkyView systems figures to indicategender.Updated the guide to include HSI requirements and other related information.Updated the guide to reflect autopilot functionality, calibration, and testinginformation. The most notable changes are to the Autopilot Servo Installation,Configuration, and Calibration Section.Expanded the Input Function Section under the Serial Port Configuration Section inthe SV-D700 / SV-D1000 Installation and Configuration Chapter.Added an important note on page 5-6 regarding the necessity of configuring airspeedlimitations for autopilot servo calibration.Specified that the SV-EMS-220 warning light pin (D37 pin 29) should not be connectedin Table 15.The SV-GPS-250 should now be configured as INPUT FUNCTION = POS 1.Clarified servo installation instructions regarding the connection point on the servoarm with the linkage hardware on page 9-6.Updated the AP Disengage/CWS Button Section on page 9-10 to say that the button isrequired instead of just highly recommended.Document number changed to 101320-003.Added GPS Fix Status information.Added Fuel Flow pulses/gallon documentation.Clarified EMS GP input compatibility.D June 2010Added information about obstacles and runways to synthetic vision section.Added information about new autopilot pitch axis settings.Added information about optional External Alarm Light connection.Added information about fuel computer settings.Updated autopilot test procedures with additional warnings and precautions.Reiterated the importance of proper ADAHRS orientation and other installationrequirements.Added note about servo self-lubrication.Clarified lack of specific boom-mount AOA/Pitot installation instructions.Added information about serial device and display connection requirements.E October 2010F December 2010Added firmware upgrade information for servos being used from D10/D100 witholder firmware.Clarified GPS serial connection wire functions and colors.Added SV-XPNDR-26X installation instructions and specifications.Added SV-ARINC-429 installation instructions and specifications.Added new requirement to connect TX and RX lines from serial devices to ALL displaysin parallel.Added information about Autopilot servos not needing lubrication.Clarified lack of boom mount AOA/Pitot mount availability.Clarified that cable-side transponder TNC connector is not provided by Dynon.Added SV-BAT-320 connection information for customers making their ownSkyView System Installation Guide - Revision Ov