SkyView System Installation Guide - Dynon Avionics

Basic SkyView Display OperationYou may also access the Setup Menu from the In Flight Setup Menu by using the ENTER FULLSCREEN SETUP MENU… option.How to Adjust Time Zone OffsetEnter the Time Zone Offset Page (SETUP MENU > SYSTEM SETUP > TIME > TIME ZONE OFFSET)and adjust the time zone accordingly. Note that this is the local offset from Zulu time.How to Configure Displayed UnitsDisplayed units can be configured for altitude, distance and speed, temperature, barometer,pressure, and volume. Displayed units are configured on the Measurement Units Page (SETUPMENU > SYSTEM SETUP > MEASUREMENT UNITS).Screens and MenusThis section lists all of the screens, menus, and pages in the SkyView system.Main MenuSome menu options are dependent on installed, networked, and/or calibratedSkyView equipment. For example, if there are no servos present in the SkyViewnetwork, the AUTOPILOT Menu will not be present on the Main Menu. This guidemakes it clear where these dependencies exist in their applicable sections.This menu is displayed right after the SkyView display boots up similar to Figure 10 and containslinks to the following menus:PFD – This menu allows users to turn the G Meter on and off, turn synthetic vision on oroff, select the NAV source, select bearing sources, and toggle bugs on and off.ENGINE – This menu allows users to control engine-related features such as adjustingthe fuel computer state (if equipped), enabling lean-assist mode, and interacting withVP-X (if equipped).AUTOPILOT – This menu allows users to toggle the status of each installed autopilot axis,set their respective modes, and engage the autopilot in a 180° turn from the currentground track. This menu is only accessible if the autopilot servos have been properlyinstalled, networked, calibrated, and testedXPNDR – This menu allows users to control a Dynon SV-XPNDR-26X transponder, ifequipped.MAP – This menu allows users to control the Navigation Mapping Software features ofSkyView. Note that this button only appears when the SV-MAP-270 software has beenpurchased and licensed, or when it is in its 30 hour free introductory trial period.SCREEN – This menu allows users to set the backlight level, toggle the state of the threeinformation pages (PFD, ENGINE, and MAP), and change the layout of the screen.3-8 SkyView System Installation Guide - Revision O