SkyView System Installation Guide - Dynon Avionics

How to Manually Adjust the Backlight Brightness or Dim LevelBasic SkyView Display OperationPress SCREEN on the Main Menu and then press DIM (this is the Dim Menu). To decrease orincrease the backlight brightness press DEC- or INC+, respectively. To set the backlightbrightness to 100%, press FULL. Press BACK twice to exit the Dim Menu and return to the MainMenu.If the display is set to automatic or external backlight brightness control, this operation willtoggle the backlight brightness control to manual mode. You can determine if there was achange in control mode by the label over button 7 in the Dim Menu. If the display was set tomanual mode in the Setup Menu, there will be no label. If the display was set to automatic orexternal, the label will toggle between MANUAL and AUTO or MANUAL and EXTERNAL,respectively. When set to MANUAL, you can change the display brightness by using the DIMitem under the joystick function menu (described in the next section).Reference the Display Setup Section of this guide for instructions on specifying the display’sbacklight brightness control method.How to Enter the Joystick Function MenuMove a joystick up, down, left, or right to enter its Joystick Function Menu. These menus areused to specify which bug that joystick adjusts if rotated. For example, joystick 1 could be set toadjust the heading bug and joystick 2 could be set to adjust the altitude bug.Figure 14 illustrates the joystick menu.To set the function of a joystick:Figure 14–Joystick Menu12. Move a joystick up, down, left, or right to enter a Joystick Function Menu.13. Choose the joystick function by moving the joystick up or down.14. Confirm the highlighted function by moving the joystick left or right.If the Map Page is onscreen, the joystick closest to the Moving Map is labeled (RNG) and is usedto adjust the map’s range. It cannot be assigned a different function.How to Enter the Setup MenusThere are two setup menus: the Setup Menu and the In Flight Setup Menu. Simultaneouslypressing and holding buttons 7 and 8 will open one of these menus. If airspeed is zero, theSetup Menu opens. If airspeed is greater than zero, the In Flight Setup Menu opens.SkyView System Installation Guide - Revision O 3-7