SkyView System Installation Guide - Dynon Avionics

` Appendix E: Serial Data OutputDYNON EMS Serial Data FormatThe following section details the format of EMS data output to the serial port:Position Width Name Pin Description1 1StartCharacter'!'2 1 Data Type3 = EMS Data. Other Dynon formats looksimilar, and may be interleaved, this bittells you what kind of data will follow.3 1 Data VersionCurrently 2. This is the version of the datarepresented below and will change if thereis a future version that changes data. Dataversion changed at SkyView version 5.1.4 8 System TimeHHMMSSFF, current Zulu time according toSkyView's internal clock which issynchronized with GPS time if GPS isavailable. HH is the hour from 00 to 23.MM is the minute from 00 to 59. SS is thesecond from 00 to 59. HHMMSS are '--------'if GPS time has never been available. FF isthe 1/16-second fraction counter from 00to 15, and may skip digits if baud rate is too12 315 4Oil Pressure(PSI)Oil Temp(deg C)Varies(see note 1)Varies(see note 1)low to send data at 16Hz.000 to 999 or XXX. Oil pressure inPSI. There must be a pressure sensornamed "OIL" for this to work. See note 2.+/- then 000 to 999 or XXX. Oiltemperature in C. There must be atemperature sensor named "OIL" for this towork. See note 2.19 4 RPM L C37 P32/34 0 to 9999. RPM from Left input.23 4 RPM R C37 P33/35 0 to 9999. RPM from Right input.27 330 333 3ManifoldPressure(inHg)Fuel Flow 1(gal/hr)Fuel Flow 2(gal/hr)C37 P26C37 P14C37 P190 to 600. Manifold Pressure in 0.1 inHg.299 = 29.9 inHg. There must be a pressuresensor named "MAP" for this to work. Seenote 2.000 to 999. Fuel flow in 1/10th Gallons PerHour. 086 = 8.6 GPH. See note 2.000 to 999. Fuel flow in 1/10th Gallons PerHour. 086 = 8.6 GPH. This is usually returnflow. See note 2.SkyView System Installation Guide - Revision O 21-7