SkyView System Installation Guide - Dynon Avionics

` Appendix C: Wiring and Electrical ConnectionsFluids Susceptibility 11.0 Equipment identified as Category X – no test requiredSand and Dust 12.0 Equipment identified as Category X – no test requiredFungus 13.0 Equipment identified as Category X – no test requiredSalt Spray 14.0 Equipment identified as Category X – no test requiredMagnetic Effect 15.0 Equipment tested to Category ZPower Input 16.0 Equipment tested to Category BXVoltage Spike 17.0 Equipment tested to Category BAudio frequency conductedsusceptibility18.0 Equipment tested to Category BInduced signal susceptibility 19.0 Equipment tested to Category ACRadio frequency susceptibility 20.0 Equipment tested to Category TTRadio frequency emission 21.0 Equipment tested to Category BLightning induced transientsusceptibility22.0 Equipment identified as Category XXXX – no test requiredLightning direct effects 23.0 Equipment identified as Category X – no test requiredIcing 24.0 Equipment identified as Category X – no test requiredElectrostatic Discharge 25.0 Equipment identified as Category X – no test requiredFire, Flammability 26.0 Equipment identified as Category CTable 71 - SV-XPNDR-26X Qualification FormsSV-XPNDR-26X ADS-B InformationSV-XPNDR-26X transponder modules include support for Extended Squitter ADS-B out. The SV-XPNDR-26X with SV-XPNDR software 2.02 or higher is a DO-260B compliant broadcastparticipant.ADS-B Parameters SupportedThe following table lists the ADS-B parameters that are transmitted by the SV-XPNDR-26Xtransponder when connected to an appropriate GPS receiver.ParameterBDS RegisterSPI 0,5Emergency Indicator 0,5Barometric Altitude 0,5Quality Indicator (NIC) 0,5AirbornePositionLatitude 0,5Longitude 0,5Quality Indicator (NIC) 0,6Surface PositionLatitude 0,6Longitude 0,6SkyView System Installation Guide - Revision O 19-17