SkyView System Installation Guide - Dynon Avionics

` Appendix C: Wiring and Electrical ConnectionsSV-EMS-221 D37PinEMS 37-pin Harness WireColorSensor (with Dynon part number ifapplicable)12 Yellow Flaps position potentiometer13 Black Available ground14 Yellow Fuel flow (100403-003)15 RedFuel flow power (100403-003) / Oilpressure (Honeywell and Rotax P/N456180 only) sensor power16 Black Available ground17 Black Available ground18 White/RedManifold Pressure Sensor Power (+5 volt)/ Kavlico Pressure Sensors19 White/Black Return fuel flow (100403-003)20 Orange/Brown Fuel level left (resistive)21 Orange/Blue Fuel level right (resistive)22 Purple/Yellow Not connected23 Purple/Green Elevator position potentiometer24 Orange/Green Ammeter shunt + (100412-000)25 Orange/Purple Ammeter shunt -26 Green/Red Not connected27 OpenRPM Signal to Rotax 912 iS Prop28 OpenController (optional)NOTE: Must be grounded to commonground with Prop Controller29 Yellow/Green Optional External Alarm Light30 Black Not connected31 White/Orange Not connected32 White/Green Not connected33 White/Blue Not Connected34 Blue Not connected35 Green Not connected36 Blue or Unwired CAN High from 912 iS ECU37 Green or Unwired CAN Low CAN High from 912 iS ECUTable 66 - SV-EMS-221 Male D37 Transducer ConnectorSV-EMS-220/221 Female D25Thermocouple Connector PinEMS 25-pinThermocoupleHarness Wire Color*Description1 Do Not Connect Do Not Connect2 Red CHT6 RED3 Red EGT6 RED4 Red CHT5 REDSkyView System Installation Guide - Revision O 19-11