SkyView System Installation Guide - Dynon Avionics

` Appendix C: Wiring and Electrical ConnectionsFigure 106–SV-EMS-220/221 ConnectorsThe SkyView GPS Receiver module (SV-GPS-250) includes four unterminated wires. These wiresmay be trimmed or spliced and extended as needed to suit the installation location. Match thecolors of these wires with the corresponding colors on the display harness as mentioned in theSerial Connection Section of the SV-GPS-250 Installation and Configuration Chapter.The SkyView Backup Battery (SV-BAT-320) has one connector. Do not add more wire into thebackup battery wire bundle.Each SkyView servo has seven unterminated wires. Reference the Autopilot Servo Installation,Configuration, and Calibration section for more information.SkyView Equipment Electrical Connector Pin-Out TablesSee tables on the follow pages for connector pin function descriptions. Tables for the USB jacks,RJ45 jack, OAT connector, and battery connector are not included.Servo Harness Pin-OutServo WireColorRedBlackGreenBlueYellowWhite/GreenWhite/BlueDescriptionPower (10 to 30 volts DC)Aircraft GroundSkyView Network Data 1ASkyView Network Data 1BAP Disengage/Control Wheel Steering(CWS) ButtonSkyView Network Data 2ASkyView Network Data 2BTable 62–Servo WiringSkyView System Installation Guide - Revision O 19-5