SkyView System Installation Guide - Dynon Avionics

` Appendix C: Wiring and Electrical ConnectionsOAT ConnectionFunctionSkyView D37 MolexConnector Pin Connector PinPower 2 3Ground 23 1Table 61 - SV-BAT-320 WiringFor customers that are converting from other Dynon products, you can use your installed OATwith the addition of the connector below. Both 100433-000 and 100433-001 are compatible.The OAT wiring can be extended as required. If you have 100433-001, ignore the red wire andconnect the yellow and blue wires to the connector below. The OAT is non-polarized; eitherwire can connect to either pin.Connector:Pins:Wire:Molex Micro-Fit P/N 43645-0200 (Digi-Key P/N WM1845-ND)Molex Micro-Fit P/N 43030-0007 (Digi-Key P/N WM1837-ND)22 AWG TefzelSkyView Equipment Electrical ConnectionsA SkyView display (SV-D700 and SV-D1000) has six connectors on the back of the unit asillustrated in Figure 104:One male D37 for connection to the SkyView Display Harness (SV-HARNESS-D37)Two male D9 SkyView network connectorsTwo Standard 4-pin USB 2.0 jacks for use with USB Series A plugs. Note that there is alsoa USB port on the SV-HARNESS-D37 for convenience.One standard 8-pin RJ45 connector for use with twisted pair category 5 Ethernet cableSkyView System Installation Guide - Revision O 19-3