SkyView System Installation Guide - Dynon Avionics

Operational StatusAppendix A: Maintenance and TroubleshootingSkyView displays give users access to vital operational information in the Display HardwareInformation Page (SETUP MENU > LOCAL DISPLAY SETUP > DISPLAY HARDWAREINFORMATION). Note that the information in this menu may be useful during troubleshooting.The information here cannot be edited on this screen; however, some parameters are editableby the user on other screens.This menu contains the following information:Display serial numberFirmware versionDisplay input voltageBackup battery charge stateOperational state of the internal battery management circuitryOperational state of the internal voltage railsScreen brightness levelLocal light sensor outputExternal light sensor outputBrightness level outputContact input statusSerial port status and current baud rateButton and joystick statesOperational hoursDisplay Serial NumberThe serial number of the display is noted here as SERIAL NUMBER: XXXXXX.Display Firmware VersionThe firmware version of the display is noted here as FIRMWARE VERSION: X.X.XX.XXX.Display Input VoltageThe display's input voltage is list here as VOLTAGE: XX.XXV.Backup Battery Module Charge StateIf there is an SV-BAT-320 backup battery connected to the display, its voltage level is shownhere as BATTERY STATUS: XX.XXV. The battery is fully charged at 12.25V. Charging a completelydischarged battery may take up to 4 hours. To conserve your aircraft battery, the SV-BAT-320 isonly charged with SkyView detects your alternator/generator to be online.SkyView System Installation Guide - Revision O 17-5