SkyView System Installation Guide - Dynon Avionics

Appendix A: Maintenance and Troubleshootingb. On the display that stayed in the plane, reconfigure SkyView Network underSETUP MENU > SYSTEM SETUP > NETWORK SETUP > CONFIGURE…c. Confirm all SkyView Network components are found, including ALL displays thatare in the aircraft.d. Exit Setup mode.8. On the recently repaired display, confirm that the tail number under SYSTEM SETUP >AICRAFT INFORMATION is now set to the actual aircraft tail number, not DYNON. Thisimplies that all settings and configurations have been synchronized from the otherdisplay.SV-ADAHRS-20X Modules1. Reinstall the ADAHRS in the aircraft.2. Reconnect all harnesses and connections as originally installed.3. Power up the entire SkyView System (all displays, modules, servos, etc).4. From any display in the aircraft, reconfigure SkyView Network under SETUP MENU >SYSTEM SETUP > NETWORK SETUP > CONFIGURE…5. Confirm all SkyView Network components are found, including the reinstalled ADAHRS.6. If the ADAHRS is the same serial number as the one you returned for repair, no furtheractions should be required. However, Dynon recommends double checking theperformance of magnetic heading and AOA calibration. If these do not seem to work aswell as they previously did, redo those calibrations.7. If the ADAHRS is not the same serial number as the one you returned for repair, allsetup and calibration steps in the SV-ADAHRS-20X Installation and Configuration sectionof the SkyView Installation manual should be performed because this ADAHRS is beinginstalled for the first time.Autopilot Servos1. Reinstall the servo in the aircraft.2. Reconnect all harnesses and connections as originally installed.3. Power up the entire SkyView System (all displays, modules, servos, etc).4. From any display in the aircraft, reconfigure SkyView Network under SETUP MENU >SYSTEM SETUP > NETWORK SETUP > CONFIGURE…5. Confirm all SkyView Network components are found, including the reinstalled servo.6. Assuming the Autopilot was previously set up and working correctly, you only need torecalibrate the servos by going to SETUP MENU > HARDWARE CALIBRATION > SERVOCALIBRATION > CALIBRATION and following the on-screen instructions.All other SkyView Network Components1. Reinstall the SkyView Network component in the aircraft.2. Reconnect all harnesses and connections as originally installed.3. Power up the entire SkyView System (all displays, modules, servos, etc).4. From any display in the aircraft, reconfigure SkyView Network under SETUP MENU >SYSTEM SETUP > NETWORK SETUP > CONFIGURE…5. No further action should be required.17-4 SkyView System Installation Guide - Revision O