SkyView System Installation Guide - Dynon Avionics

Appendix A: Maintenance and TroubleshootingReturning SkyView Components to Service after RepairSkyView Network enabled components such as modules and servos are shipped in a “like new”state after repair. To return a SkyView Network component to SkyView Network, follow thefollowing directions. Note that there are 3 different procedures for returning SkyView SV-D1000/SV-D700 displays to service, depending on how the display is returned :SV-D1000 / SV-D700 Display Scenario 1: When the documentation furnished with therepaired display indicates that is being returned to you with the exact samesettings/configuration as it was sent to Dynon with1. In this case, the display contains EXACTLY the same configuration as it did when yousent it in. If your system was working properly before the display failed and was sent infor repair:a. Reinstall the display, reconnecting all harnesses and connections as originallyinstalled.2. Power up the entire SkyView System (all displays, modules, servos, etc)3. If this is the only display installed:a. Reconfigure SkyView Network under SETUP MENU > SYSTEM SETUP > NETWORKSETUP > CONFIGURE…b. Confirm all SkyView Network components are found, including ALL displays thatare in the aircraft.4. If there is another display installed in the aircraft:a. Using a display that never left the aircraft (and is presumably configured andworking correctly):i. Reconfigure SkyView Network under SETUP MENU > SYSTEM SETUP >NETWORK SETUP > CONFIGURE…ii. Confirm all SkyView Network components are found.5. Confirm that all settings, behavior, and configuration are normal.6. If your SkyView system is not working normally, contact Dynon Avionics TechnicalSupport for further assistance.SV-D1000 / SV-D700 Display Scenario 2: When repaired display is the ONLY display inthe aircraft, and the documentation furnished with the repaired unit indicates thatthe display was shipped “like new”1. Reinstall the display, reconnecting all harnesses and connections as originally installed.2. Power up the entire SkyView System (all displays, modules, servos, etc).3. If you have a settings backup on a USB memory stick:a. Load settings backup via SETUP MENU > SYSTEM SOFTWARE > LOAD FILES.b. Confirm that the tail number under SYSTEM SETUP > AIRCRAFT INFORMATION isnow set to the actual aircraft tail number, not DYNON.c. Reconfigure SkyView Network under SETUP MENU > SYSTEM SETUP > NETWORKSETUP > CONFIGURE…d. Confirm all SkyView Network components are found.17-2 SkyView System Installation Guide - Revision O