SkyView System Installation Guide - Dynon Avionics

Accessory Installation and ConfigurationIf you have more than one SkyView display, note that like all other serial devices, the encoderconverter module needs to be connected to a serial TX from each display simultaneously. Seethe Serial Devices section for more information about this requirement.Any general purpose SkyView display serial port is compatible with the Encoder Convertermodule. Connect the Encoder’s input (green or red) to an appropriate wire on the displayharness (reference the SV-D700 / SV-D1000 Electrical Installation Section for details on whichpins to use). Also ensure that the display and the Encoder Converter Module share a ground.Figure 94 illustrates the basic electrical connection between the SkyView display and theEncoder Converter module.TransponderSkyView DisplayDB37 ConnectorTXGNDSkyView Display Serial TransmitShared GroundEncoder ConverterModuleGreen WireBlack WireYellowGreenWhite/BlueBlueOrangeWhite/RedWhite/GreenWhiteWhite/BlackUnconnectedUnconnectedA1A2A4B1B2B4C1C2C4D4StrobeThe Encoder Converter Moduleis compatible with all SkyViewdisplay serial ports.RedBlackFigure 94–Encoder Converter Module Electrical Connections10-30 voltsGroundSerial Port Setup–DYNON CONVERTER FormatEnter the Serial Port Setup Menu (SETUP MENU > SYSTEM SETUP > SERIAL PORT SETUP) oneach display and configure the appropriate serial port for use with the Encoder Serial-to-GrayCode Converter module with the following settings:SERIAL # IN DEVICE:NONESERIAL # IN FUNCTION:NONESERIAL # IN/OUT BAUD RATE: 1200SERIAL # OUT DEVICE: DYNON CONVERTERCapacitance-to-Voltage Converter Installation and ConfigurationDynon Avionics’ Capacitance-to-Voltage Converter (Dynon P/N 100654-000) is suitable forgeneral use with most capacitive plate fuel level sensors. It accepts an input via a female BNCand outputs a DC voltage signal that can be read by the SV-EMS-220/221. It requires 10 to 15volts DC for power and draws minimal current. We recommend that you connect theSkyView System Installation Guide - Revision O 15-13