SkyView System Installation Guide - Dynon Avionics

Heat Status on EMS PageAccessory Installation and ConfigurationIf an SV-EMS-220 or SV-EMS-221 is installed for engine monitoring, the status of the HeatedPitot Controller can be displayed on the EMS display.1. Connect the heater status output wire to the any of the following General PurposeInputs that are not already in use: Pins 4, 7, 9, 10, 11. 12, 20, or 21. (General PurposeInputs Pins 6, 8, 22, and 31 are more specialized and should be reserved for other use.)2. SETUP MENU > EMS SETUP > SENSOR INPUT MAPPINGC37 Px (pin that the heater status output is connected to) set toCONTACT | CONTACT | PHEAT (or a CUSTOM name of your choice).3. SETUP MENU > EMS SETUP > SENSOR SETUP > PHEAT CONTACTALARM OFFRANGE 1ENABLE YESNAME ONCOLOR GREENTOP 5.0VBOTTOM 2.1VRANGE 2ENABLE YESNAME OFFCOLOR REDTOP 2.0VBOTTOM 0.0VRANGE 3 (and RANGE 4 and RANGE 5)ENABLE NO(other parameters are ignored when ENABLE set to NO)4. SETUP MENU > EMS SETUP > SCREEN LAYOUT EDITORSENSOR (button)Select PHEAT (or custom name) CONTACTACCEPT (button)Adjust size of the icon to your preference.Adjust location of the icon to your preference.SAVE (button)5. Repeat step 5 for 20%, 50%, and 100% layouts as desired6. Test:When Pitot Heater Controller is OFF (or fault), EMS screen should display RED indicatorwith text OFF.When Pitot Heater Controller is ON, EMS screen should display GREEN indicatorwith text ON.SkyView System Installation Guide - Revision O 15-7