SkyView System Installation Guide - Dynon Avionics

Heater Controller Module Physical InstallationFigure 89 shows the dimensions of the heater controller module.Accessory Installation and ConfigurationFigure 89–Heater Controller Module DimensionsThe heater controller module requires #6 mounting hardware and should ideally be mountedclose to the AOA/Pitot Probe. When mounting the controller close to the probe, ensure that itis close enough for its wires to mate with the probe’s wires, with room for strain-relief. If youfind it difficult to mount the controller in the wing, or simply wish for the controller to bemounted closer to the battery, you must extend the lines using the correct wire gauge asdescribed in Appendix C: Wiring and Electrical Connections.SkyView System Installation Guide - Revision O 15-3