SkyView System Installation Guide - Dynon Avionics

Post Installation ChecksSV-ADSB-470 Installation, Configuration, and TestingAfter the SV-ADSB-470 has been configured, confirmation that communication has beenestablished with the module by performing the following procedure: Go to SETUP MENU > ADS-B STATUS. Confirm that the DEVICE line reads SV-ADSB-470. Use the STATUS line to determine whether the SV-ADSB-470 is successfullycommunicating with SkyView. It can also be used to determine whether the as well as ifit is able to see any ADS-B ground stations. The status line can display any of thefollowing states:o NOT FOUND: The device is not communicating with SkyView. This usually impliesa connectivity/wiring problem between the SV-ADSB-470 and SkyView, or thatthe SV-ADSB-470 is not receiving power.o NO SIGNAL: The device is communicating with SkyView, but data is not beingreceived from an ADS-B ground station. This may occur when you are on theground and do not have line-of-sight reception of an ADS-B ground station, or ifyou are in the air and are out of range of all ADS-B ground stations. If there is anADS-B ground station in range, and NO SIGNAL is persistently displayed, it mayimply a connectivity problem with your ADS-B antenna or an installation issuethat is preventing the ADS-B antenna from receiving ADS-B ground stationbroadcasts. Note that when in flight, the Map Page displays a status widget in itslower left corner that contains the same information as this menu status item.That widget will be more useful for ascertaining proper operation once you arein the air and are most likely to be receiving data from ADS-B ground stations.o RECEIVING: The device is communicating with SkyView AND data is beingreceived from an ADS-B ground station. You may also observe the red LED light on the physical SV-ADSB-470 module to confirmproper hardware operation:o Flashing Fast: The module is operating normally, is configured andcommunicating with SkyView over a correctly-configured serial port, and isreceiving GPS data from SkyView.o Flashing Slowly: The module is operating, but is not fully communicating withSkyView.o Off: The module is not receiving power.o On Solid - the module is receiving power, but is not operating normally. ContactDynon Technical Support for assistance if power cycling your avionics does nothelp.SkyView System Installation Guide - Revision O 14-9