SkyView System Installation Guide - Dynon Avionics

SV-ADSB-470 Installation, Configuration, and TestingSerialPort1234Power/Ground InputSkyView D37Pin 3 (RX) Brown/VioletPin 4 (TX) Brown/OrangePin 5 (RX) Yellow/VioletPin 6 (TX) Yellow/OrangePin 7 (RX) Green/VioletPin 8 (TX) Green/OrangePin 9 (RX) Blue/VioletPin 10 (TX) Blue/OrangeSV-ADSB-470 D9Pin 3 (TX)Pin 2 (RX)Pin 3 (TX)Pin 2 (RX)Pin 3 (TX)Pin 2 (RX)Pin 3 (TX)Pin 2 (RX)Table 46 - Example SkyView/SV-ADSB-470 Serial Port ConnectionsThe SV-ADSB-470 can be powered by 10-30 Volts DC. 22 AWG wire is sufficient for wire runs upto 50’ for this application. Use an appropriate size fuse or circuit breaker for power supplyprotection to the SV-ADSB-470. If 22 AWG wire is used, a 1 or 3 amp fuse/circuit breaker isacceptable. The SV-ADSB-470 must be connected to aircraft power, and not to any of SkyView’spower outputs.Approximate currentApproximate currentPower Specificationsconsumption at 12 volts DC consumption at 24 volts DCSV-ADSB-470 0.2 amps 0.1 ampsSerial RX/TXTable 47 - SV-XPNDR-26X Power ConsumptionAll communication between the SV-ADSB-470 module and SkyView is accomplished via a singlebidirectional serial connection. To accomplish this:Choose an unused serial port on each display to connect the SV-ADSB-470 to. Note thatboth the TX and RX sides of the serial port are needed, and both the RX and TX linesmust be connected to all displays in parallel. The same numerical serial port must beused on each display.Connect the SV-ADSB-470 TX wire (pin 3) to the SkyView serial RX of your choosing. Ifyou have multiple displays, the SV-ADSB-470 TX wire must be connected to the sameserial RX wire on each display.Connect the SV-ADSB-470 RX wire (pin 2) to the SkyView serial TX of your choosing. Ifyou have multiple displays, the SV-ADSB-470 RX wire must be connected to the sameserial TX wire on each display.SkyView System Installation Guide - Revision O 14-5