SkyView System Installation Guide - Dynon Avionics

SV-ADSB-470 Installation, Configuration, and Testingsources of these products. You may also find it helpful to own a pin insertion/extraction tool aswell.Additional harness construction and wiring information can be found in Appendix C: Wiring andElectrical Connections.The SV-ADSB-470 has a single D9 female connector which provides the data and power inputsto the module. A single BNC connector attaches to the antenna.SV-ADSB-470 Interface – Pinout (Female D9 on module / Male D9 on harness)Pin Function Notes1 10-30V DC Connect to Aircraft Power2 SV-ADSB-470 Serial RX Data Input from SkyView3 SV-ADSB-470 Serial TX Data Output to SkyView4 Ground Connect to Aircraft Ground5 No Connect -6 No Connect -7 No Connect -8 No Connect -9 No Connect -Table 45 - SV-ADSB-470 Female D9 PinoutThe pin out depicted in Figure 88 below depicts the view from the rear of your male D9connector – the view you will have of your harness connector as you are inserting pins into theharness. Note that the pin numbers are labelled on the face of both the female and maleconnector.Figure 88 - SV-ADSB-470 connector diagram (from back side of male D9 connector on the wiring harness)The following table shows the connections for each of SkyView’s nominally available serial ports(serial port 5 is usually used for connection to the SV-GPS-250 module. Only ONE of thefollowing serial ports will be used:14-4 SkyView System Installation Guide - Revision O