SkyView System Installation Guide - Dynon Avionics

Vertical Power VP-X Integration and Configuration> LICENSE > LICENSE CODE. If you have more than one display in the aircraft, choose oneto install it onto and provide information for only that display. Once any display islicensed, all connected displays in the Aircraft can use the Vertical Power softwarefeatures.4. An SV-VPX-290 VP-X Software Certificate may be purchased from Dynon Avionics or anyauthorized Dynon Avionics retailer. This certificate can be redeemed for a license codethat can be entered in SETUP MENU > LOCAL DISPLAY SETUP > LICENSE > LICENSE CODE.To redeem a certificate simply follow the instructions on the certificate itself. Similar tothe above, you will need to redeem your certificate by visitinglicense.dynonavionics.com with your SkyView display model and serial number ready.Alternatively, you can call Dynon Avionics directly at 425-402-0433 to redeem acertificate.Physical and Electrical InstallationRefer to the Vertical Power installation documentation for instructions on the physical andelectrical installation of the VP-X system.Up-to-date installation manuals, wiring diagrams, and “how-to” guides for the VP-X system canbe found at http://verticalpower.com/documents/.SkyView modules such as the SV-ADAHRS-20X, SV-EMS-220/221, and SV-ARINC-429 receive power via the SkyView Network. Their power supplies are managedentirely by the SV-D1000 and SV-D700 displays, and cannot be separatelymonitored by the VP-X system. However, SkyView components that have powersupplied by ship’s power, such as the SV-XPNDR-26X, Autopilot Servos, and theheated AOA/pitot probe can have their power monitored by the VP-X by routingthe power connections for those components via the VP-XA Dynon SkyView D37 harnesses for a single display contains a pair of power andground wires. These pairs of wires are a SINGLE power input, and must beconnected to a single VP-X input when using the VP-X to provide power toSkyView displays. The dual wiring scheme is needed to provide adequate power tothe SkyView displays given the electrical constraints of the particular wires and D-sub connections used. These wires should not be sent to separate power channelsor be considered redundant power sources.Serial Port ConnectionAll communication between the VP-X system and SkyView is accomplished via a singlebidirectional serial connection. To accomplish this:Choose an unused serial port on each display to connect the VP-X to. Note that both theTX and RX sides of the serial port are needed, and both the RX and TX lines must be13-2 SkyView System Installation Guide - Revision O