SkyView System Installation Guide - Dynon Avionics

SV-ARINC-429 Installation and ConfigurationAdditional mounting location, orientation, and other installation requirements are described inthe System Planning section earlier in this manual. Please review this section when physicallyinstalling your with SV-ARINC-429 module(s).Dynon does not provide mounting hardware with SV-ARINC-429 module. The mounting tabs oneach side of the module have holes sized for #10 fasteners, but it is up to the installer to decidehow the SV-ARINC-429 will be secured to the aircraft.Follow recommended torque practices when tightening the mounting hardware. Do not rivetthe SV-ARINC-429 to the aircraft as this will hinder future removal if necessary.SkyView Network ConnectionConnect the SV-ARINC-429 module to the SkyView network using the hardware mentioned inthe SkyView System Construction Section or using equivalent hardware.If you have to install a connector on the end of a network cable, insert all pins into the D9connector. Refer to Appendix C: Wiring and Electrical Connections for details on connector pinoutsand wire colors.Remember to configure the network as described in the Network Setup and Statussection after connecting all modules to a display.ARINC-429 Device ConnectionHarness ConstructionBecause the SV-ARINC-429 can be connected to a variety of devices, the harness requirementswill vary from airplane to airplane. Therefore, Dynon Avionics does not supply premanufacturedharnesses for the SV-ARINC-429 module. Instead, your SV-ARINC-429 shippedwith enough connectors and pins to generate a wide variety of harness configurations. Refer tothe sections below for detailed wiring information.If you do not own a D-sub machined-pin crimping tool, they can be obtained for under $50 frommany retailers. See http://wiki.dynonavionics.com/Tools_not_supplied_by_Dynon for knownsources of these products. You may also find it helpful to own a pin insertion/extraction tool aswell.Additional harness construction and wiring information can be found in Appendix C: Wiring andElectrical Connections.The SV-ARINC-429 has a single 25 pin female D-Sub socket which is used for all dataconnections to your compatible ARINC-429 device. The pin out depicted in Figure 78 belowdepicts the view from the rear of your male D25 connector – the view you will have of yourharness connector as you are inserting pins into the harness. Note that the pin numbers arelabelled on the face of both the female and male connector.12-2 SkyView System Installation Guide - Revision O