SkyView System Installation Guide - Dynon Avionics

More documents

Recommendations

Info

SV-XPNDR-26X Installation, Configuration, and Testingdetermine whether the aircraft is in flight or not by using a combination of GPS and air datachanges from SkyView.Note that after the 2.02 transponder update, only the SV-XPNDR-261 is capable of meeting the2020 ADS-B Out mandate, because of power transmission requirements that the FAA ADS-Brules imposes. In other words, the SV-XPNDR-262, even if it is updated to this software, cannotbe used for 2020 ADS-B Out compliance credit.Transponder Software Version (SW) 2.02 Labeling Requirements(US Registered / Operated Aircraft Only)This section applies to aircraft operated or registered in the US only.In the US, updating your transponder software to SW version 2.02 REQUIRES that the physicaltransponder module be labeled to indicate the new TSO authorization. Failure to perform thisphysical modification at the same time as the software update will result in a transponder thatis not considered airworthy by the FAA.Applicability/ComplianceIf your transponder shipped from Dynon Avionics after September 2012, it likely shipped withsoftware version 2.02 and is labeled with its TSO C166b appropriately. However, this is notauthoritative.To determine whether your transponder has an optional software update available for it, whichwill require that it be labeled should you choose to update it:1. Go to SETUP MENU > TRANSPONDER SETUP > STATUS. If the STATUS line is yellow,there is a software update available for the transponder.2. If you choose to update the transponder, you need to physically label it concurrently.3. Before you press LOAD in the above menu, first, please visithttp://www.dynonavionics.com/transponder to download the label which you canprint out and apply to the transponder module.4. When you have the label available, go to SETUP MENU > TRANSPONDER SETUP >STATUS and press the LOAD button and follow the instructions to update the software.5. You must apply the label before the transponder’s next use:a. Cut out the label contained within the PDF.b. Permanently affix the label to your physical SV-XPNDR-26X module. Do not coverany existing labels.c. Ensure that the method that you use to secure the label is durable. Fullycovering the label with transparent packing tape would satisfy this requirement,for example.11-20 SkyView System Installation Guide - Revision O
12. SV-ARINC-429 Installation and ConfigurationSkyView can connect to advanced GPS/NAV devices like the Garmin GNS 430/530 and similarVia the SV-ARINC-429 module.Read and understand the System Planning Chapter before installing the SV-ARINC-429.Figure 76 is a high-level overview of a suggested and installation and configuration procedurefor the SV-ARINC-429.Figure 76 – Suggested SV-ARINC-429 Installation and Configuration ProcedurePhysical InstallationThe diagram below shows the important mounting dimensions of the SV-ARINC-429 modulewith electronic connections.Figure 77 - SV-ARINC-429 Mounting Dimensions with Electrical ConnectionsSkyView System Installation Guide - Revision O 12-1
Page 1:
SkyViewSystem Installation GuideThi
Page 6 and 7:
Revision Revision Date Descriptionh
Page 8 and 9:
Revision Revision Date DescriptionC
Page 11 and 12:
Table of ContentsContact Informatio
Page 13 and 14:
Table of ContentsTachometer .......
Page 15:
Table of Contents19. Appendix C: Wi
Page 18 and 19:
IntroductionAbout this GuideIn the
Page 21 and 22:
2. System PlanningInstallers should
Page 23 and 24:
System PlanningTemperature Specific
Page 25 and 26:
System PlanningIn order to provide
Page 27 and 28:
System Planningferrous material suc
Page 29 and 30:
SV-XPNDR-26XSystem PlanningThe SV-X
Page 31 and 32:
System PlanningSkyView System Const
Page 33 and 34:
System PlanningTest SkyView Network
Page 35 and 36:
System PlanningDynon Part NumberSV-
Page 37 and 38:
System PlanningFigure 8- SkyView Sy
Page 39:
System PlanningSoftware is in use.
Page 42 and 43:
Basic SkyView Display OperationDisp
Page 44 and 45:
Basic SkyView Display OperationA bu
Page 46 and 47:
Basic SkyView Display OperationBasi
Page 48 and 49:
Basic SkyView Display OperationYou
Page 50 and 51:
Basic SkyView Display Operationthis
Page 52 and 53:
Basic SkyView Display OperationFlig
Page 54 and 55:
Basic SkyView Display OperationFirm
Page 57 and 58:
4. SV-D700 / SV-D1000 Installation
Page 59 and 60:
SV-D700 / SV-D1000 Installation and
Page 61 and 62:
Page 63 and 64:
Page 65 and 66:
Page 67 and 68:
Internal Time KeepingSV-D700 / SV-D
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
5. SV-ADAHRS-20X Installation and C
Page 85 and 86:
SV-ADAHRS-20X Installation and Conf
Page 87 and 88:
SV-OAT-340 Location and Installatio
Page 89 and 90:
Measurement UnitsSV-ADAHRS-20X Inst
Page 91 and 92:
Page 93 and 94:
6. SV-MAP-270 Navigation Mapping So
Page 95 and 96:
Page 97:
Page 100 and 101:
SV-EMS-220/221 Installation and Con
Page 102 and 103:
Page 104 and 105:
Page 106 and 107:
Page 108 and 109:
Page 110 and 111:
Page 112 and 113:
Page 114 and 115:
Page 116 and 117:
Page 118 and 119:
Page 120 and 121:
Page 122 and 123:
Page 124 and 125:
Page 126 and 127:
Page 128 and 129:
Page 130 and 131:
Page 132 and 133:
Page 134 and 135:
Page 136 and 137:
Page 138 and 139:
Page 140 and 141:
Page 142 and 143:
Page 144 and 145:
Page 146 and 147:
Page 148 and 149:
Page 150 and 151:
Page 152 and 153:
Page 154 and 155:
Page 156 and 157:
Page 158 and 159:
Page 160 and 161:
Page 162 and 163:
Page 165 and 166: 8. SV-GPS-250 Installation and Conf
Page 167 and 168: SV-GPS-250 Installation and Configu
Page 169 and 170: 9. SV-BAT-320 InstallationThis chap
Page 171 and 172: SV-BAT-320 Installationvoltages to
Page 173: SV-BAT-320 InstallationTest Procedu
Page 176 and 177: Autopilot Servo Installation, Confi
Page 197 and 198: 11. SV-XPNDR-26X Installation, Conf
Page 199 and 200: SV-XPNDR-26X Installation, Configur
Page 215: Post Installation ChecksSV-XPNDR-26
Page 219 and 220: SV-ARINC-429 Installation and Confi
Page 221 and 222: ARINC Device ConnectionsSV-ARINC-42
Page 223 and 224: SV-ARINC-429 Installation and Confi
Page 225: SV-ARINC-429 Installation and Confi
Page 228 and 229: Vertical Power VP-X Integration and
Page 230 and 231: Vertical Power VP-X Integration and
Page 233 and 234: 14. SV-ADSB-470 Installation, Confi
Page 235 and 236: SV-ADSB-470 Installation, Configura
Page 241: Post Installation ChecksSV-ADSB-470
Page 244 and 245: Accessory Installation and Configur
Page 258 and 259: SV-COM-C25 Installation, Configurat
Page 266 and 267:
SV-COM-C25 Installation, Configurat
Page 268 and 269:
Page 270 and 271:
Page 272 and 273:
Page 274 and 275:
Appendix A: Maintenance and Trouble
Page 276 and 277:
Page 278 and 279:
Page 280 and 281:
Page 282 and 283:
Page 284 and 285:
Appendix B: SpecificationsSkyView E
Page 286 and 287:
Appendix B: SpecificationsSV-XPNDR-
Page 288 and 289:
Appendix B: SpecificationsSV-COM-C2
Page 290 and 291:
Appendix C: Wiring and Electrical C
Page 292 and 293:
Page 294 and 295:
Page 296 and 297:
Page 298 and 299:
Page 300 and 301:
Page 302 and 303:
Page 304 and 305:
Page 306 and 307:
Page 309 and 310:
20. Appendix D: SV-EMS-220/221 Sens
Page 311 and 312:
21. Appendix E: Serial Data OutputA
Page 313 and 314:
` Appendix E: Serial Data OutputPos
Page 315 and 316:
Page 317 and 318:
` Appendix E: Serial Data OutputDYN
Page 319 and 320:
Page 321 and 322:
` Appendix E: Serial Data Output ZZ
Page 323:
` Appendix E: Serial Data OutputNME
Page 326:
Appendix F: User Data LogsThe Recen
show all

SkyView System Installation Guide - Dynon Avionics

Create successful ePaper yourself

Delete template?

Save as template?