SkyView System Installation Guide - Dynon Avionics

10. Autopilot Servo Installation, Configuration, and CalibrationThis chapter contains generic mechanical and electrical installation guidelines for the Dynonservos mentioned in Table 39. Plane-specific kits purchased from Dynon contain detaileddrawings and diagrams which are intended to be used in conjunction with this guide as acomplete set of installation instructions. A complete list of aircraft mounting kits is available onthe current Price List/Order Form at store.dynonavionics.com. Drawings and diagrams are alsoavailable at docs.dynonavionics.com.Figure 56 is a high-level overview of a suggested servo installation, configuration, andcalibration procedure.Research Dynonresources forautopilotapplicationChoose servolocation(s)Use premademountingbracket(s)?NoFabricatemountingbracket(s)YesInstall mountingbracket(s) withRange of MotionLimiting BracketInstall servo(s)Install linkagehardwareInstall servopower wiring withfuse(s) orbreaker(s)Installdisengage/CWSbutton and wiringInstall SkyViewnetwork cablingConfigureSkyView Network*Calibrate and testservosConfigure pitchand roll axes anddisengage/CWSoptionsFlight test and finetune autopilot*Assumes SV-D700 or SV-D1000 is properly installed and working.Figure 56–Suggested Servo Installation, Configuration, and Calibration ProcedureOf note to customers that are either upgrading their D10A/D100 series products toSkyView: Autopilot servos shipped prior to December 1st, 2009, require that theybe upgraded to Version 5.2 Software or higher before they can connect to aSkyView Network. Autopilot servos shipped prior to this date MUST be upgraded tothe latest version using a D10/D100 Series product BEFORE they are connected toSkyView. This will then allow the SkyView Network to communicate with the servo.SkyView System Installation Guide - Revision O 10-1