SkyView System Installation Guide - Dynon Avionics

SV-EMS-220/221 Installation and ConfigurationNow, locate the widget on the screen by moving the joysticks left, right, up, and down. Onceyou have decided on a location for this widget, you can add and configure more widgets (pressSENSOR to add another widget and follow the procedure on the preceding page) and then savethe page layout by pressing SAVE.Specific Widget and Info Item Data RequirementsIn order for the % Power and LOP/ROP status info items to calculate values, the following datamust be present / conditions must be met:Barometric altitude (from an SV-ADAHRS-20X) must be present.EMS SETUP > ENGINE INFORMATION > ENGINE TYPE must be set toLycoming/Continental. Percent power calculations are not available for other enginetypes at this time.EMS SETUP > ENGINE INFORMATION > HORSEPOWER must be set.OAT sensor installed / working.Fuel flow sensor must be installed and configured.MAP sensor must be installed and configured.EMS Sensor CalibrationFuel level sensors and position potentiometers must be calibrated. Your SkyView display utilizesonscreen wizards that help you do this. Go to the EMS Calibration Menu to access thesewizards (SETUP MENU > HARDWARE CALIBRATION > EMS CALIBRATION).SkyView System Installation Guide - Revision O 7-65