SkyView System Installation Guide - Dynon Avionics

SV-EMS-220/221 Installation and ConfigurationExample Contact Sensor SetupAssume this sensor was mapped on the Sensor Input Mapping Wizard as:PIN # FUNCTION SENSOR NAMEC37 P9 CANOPY Contact CANOPYNow, we want to configure its alert and graphical properties. Go to the Sensor Setup Menu andopen the CANOPY CONTACT Page (SETUP MENU > EMS SETUP > SENSOR SETUP > CANOPYCONTACT).Note that although inputs set up as contacts can physically accept up to 15V (sothat they can accept nominal aircraft voltage as one of their two states), themaximum the EMS can measure is 5.0V. This means that as depicted below, thetwo measured ranges should be set to 0-2.5V and 2.5-5V to measure the absenceand presence of power.Configure CANOPY CONTACT with the following properties: ALARM: OFF MAXIMUM GRAPHICAL DISPLAY: 5.0 VOLTS MINIMUM GRAPHICAL DISPLAY: 0.0 VOLTS RANGE 1o ENABLEYESo NAMEOPENo COLORREDo TOP5.0 VOLTSo BOTTOM2.5 VOLTS RANGE 2o ENABLEo NAMEo COLORo TOPo BOTTOM RANGE 3o ENABLEo NAMEo COLORo TOPo BOTTOM RANGE 4o ENABLEo NAMEo COLORo TOPo BOTTOM RANGE 5o ENABLEYESCLOSEDGREEN2.5 VOLTS0.0 VOLTSNOR3GREEN20.0 VOLTS10.0 VOLTSNOR4YELLOW10.0 VOLTS5.0 VOLTSNOFigure 44–Anatomyof a Widget: CanopyContact7-60 SkyView System Installation Guide - Revision O