SkyView System Installation Guide - Dynon Avionics

SV-EMS-220/221 Installation and Configurationfull fuel and an optional second “preset” fuel quantity. Once programmed, typical aircraft fuelloads are then quickly recalled under in the EMS > FUEL menu as described in the Pilots UserGuide.There are three fuel computer options, found under SYSTEM SETUP > SYSTEM SETUP >AIRCRAFT INFORMATION. They are only applicable if you have a fuel flow sensor installed:Total Fuel Capacity–set this to the total usable fuel on board when the tanks are full.Once this is set, the pilot is prevented from accidentally setting more than this amountof fuel on board.Preset Fuel Capacity–this can be used to quickly recall a second, non-full starting fuelstate. For example, if your tanks have tabs so that you can easily fill to ¾ of your normalfull fuel load, you would enter this number here so that you can quickly set your fuelcomputer to this second preset when you fill to the tabs.Fuel Added Detect–When set to yes, SkyView will check for discrepancies between thephysical fuel quantity senders and the fuel computer’s calculated fuel load on boot-up.If one is found, SkyView will prompt the user to adjust the fuel computer’s fuel state.This option should only be set to YES on one display if you have more than one in thesystem.Manual EMS Sensor Settings ConfigurationGo to the Sensor Setup Menu (SETUP MENU > EMS SETUP > SENSOR SETUP) to manuallyconfigure the settings of an EMS sensor. Once there, a list of every mapped sensor is displayed.Follow this basic procedure to configure sensor settings:1. Choose a sensor. Scroll through the menu to a sensor and move the joystick right toenter to the sensor configuration menu.2. Set the alarm. Scroll to the ALARM configuration line, move the joystick right to enterthe Alarm Adjust Menu, choose the appropriate alarm for the sensor, and then pressACCEPT. Press BACK to return to the sensor configuration menu.3. Set the graphical display limits. Scroll to the MAXIMUM and MINIMUM GRAPHICALDISPLAY lines, move the joystick right to enter the respective menus, adjust the valuesappropriately - and then press ACCEPT. Press BACK to return to the sensor configurationmenu.4. Set the ranges. Scroll the menu and configure enable, color, and top and bottom.5. Save the settings. Press BACK to return to the Sensor Setup Menu. Press EXIT to returnto the Main Menu.The examples on the following pages show four configured sensors: a voltmeter, a contact,RPM, and an oil temperature sensor.7-58 SkyView System Installation Guide - Revision O