SkyView System Installation Guide - Dynon Avionics

SV-EMS-220/221 Installation and ConfigurationAll sensors and transducers are mapped in the Sensor Input Mapping Wizard. As mentionedearlier, some pins are compatible with a variety of sensors, while other pins have fixedfunctionality. A sensor is defined in the Sensor Input Mapping Wizard by the followingparameters: Pin #–the pin or set of pins the sensor is connected to Function–the phenomenon the sensor measures (e.g., pressure and temperature) Sensor–the physical part used, for example 0-80 PSI Fluid Pressure (100411-001) Name–a six character field that names the sensor for use by the pilot in flight.Loading a premade sensor mapping file onto SkyView can save installation time.These files define sensors with the four parameters mentioned.Table 37 shows an example oil pressure sensor map on pin 6 of the SV-EMS-220/221 D37connector.PIN # FUNCTION SENSOR NAMEC37 P6 PRESSURE 0-150 PSI FLUID PRESSURE (100411-002) OILManual Sensor MappingTable 37–Example Sensor MapAppendix D: SV-EMS-220/221 Sensor Input Mapping Worksheet is a useful toolduring sensor mapping. This section is intended for use only if the premade sensormapping file does not contain the sensor definitions needed for your installation.Go to the Sensor Input Mapping Wizard (SETUP MENU > EMS SETUP > Sensor Input Mapping…)and use the following procedure to manually map a sensor or transducer:1. Scroll through the different parameters using a combination of joystick turns andmovements in the up, down, left, and right motions. The selected parameter ishighlighted and its text is enlarged.2. Press SELECT to open the parameter for editing.3. Edit the parameter using a series of joystick turns and movements.4. Save the parameter edit by pressing ACCEPT or by moving either joystick to the right orthe left. Press CANCEL to back out of the parameter edit mode without saving.EMS Sensor SettingsMapped sensors that are displayed on the Engine Page should have their alert and graphicalproperties appropriately configured. This section explains the settings that are required for EMSsensors, contains instructions for manually configuring sensor settings, and uses several sensorsettings examples to further explain sensor settings.SkyView EMS sensor settings are defined by the following parameters in the Sensor SetupMenu:AlarmSkyView System Installation Guide - Revision O 7-55