SkyView System Installation Guide - Dynon Avionics

SV-EMS-220/221 Installation and ConfigurationOil Pressure SensorThe oil pressure sensor may be connected to any general purpose input pin on the SV-EMS-220/221’s D37, however, we recommend that it be connected to pin 6 on this connector.The SV-EMS-220/221 supports several oil pressure sensor installations. The Dynon-suppliedsensor and the Rotax and Jabiru pre-installed sensors are the most common.Kavlico Brand Dynon-Supplied Brand Oil Pressure Sensor (101693-000)Mount the oil pressure sensor securely using an Adel clamp or other method such as using atransducer mounting block on the firewall. Dynon does not recommend mounting the sensordirectly to the engine to minimize the chance of mechanical failure of the transducer due toengine vibration. Unlike Dynon’s older oil pressure sensor, the Kavlico pressure sensor has adedicated ground wire, eliminating the need to use the sensor case as ground.Connect the red wire to SV-EMS-220/221 D37 pin 18 (red/white). This connection may beshared with other sensors, depending on your installation.Connect the green wire to SV-EMS-220/221 D37 general purpose input of your choosing(nominally pin 6)Connect the black wire to Ground. Any the black ground wires on the SV-EMS-220/221 D37harness are suitable for this purpose.SkyView System Installation Guide - Revision O 7-35