SkyView System Installation Guide - Dynon Avionics

SV-EMS-220/221 Installation and ConfigurationExample Rotax 912 iS (SV-EMS-221)EMS 37-pin HarnessPinWire ColorSensor (with Dynon part number ifapplicable)1 Red Battery voltage (voltmeter input)2 Yellow or Unwired Not connected3 Black Available ground4 Purple/Blue Not connected5 Black Available ground6 White/Yellow Not connected7 White/Brown Not connected8 Brown Fuel pressure (101716-000)9 Brown/Blue Not connected10 Brown/Yellow Not connected11 Orange Not connected12 Yellow Flaps position potentiometer13 Black Available ground14 Yellow Fuel flow (100403-003)15 RedFuel flow power (100403-003) / Oil pressure(Honeywell and Rotax P/N 456180 only)sensor power16 Black Available ground17 Black Available ground18 White/RedManifold Pressure Sensor Power (+5 volt) /Kavlico Pressure Sensors19 White/Black Return fuel flow (100403-003)20 Orange/Brown Fuel level left (resistive)21 Orange/Blue Fuel level right (resistive)22 Purple/Yellow Not connected23 Purple/Green Elevator position potentiometer24 Orange/Green Ammeter shunt + (100412-000)25 Orange/Purple Ammeter shunt -26 Green/Red Not connected27 Open28 OpenRPM Signal to Rotax 912 iS Prop Controller(optional)NOTE: Must be grounded to common groundwith Prop Controller29 Yellow/Green Optional External Alarm Light30 Black Not connected31 White/Orange Not connected32 White/Green Not connected33 White/Blue Not Connected34 Blue Not connectedSkyView System Installation Guide - Revision O 7-25