SkyView System Installation Guide - Dynon Avionics

SV-EMS-220/221 Installation and ConfigurationEMSModuleOutputPinOutputCurrentLimitWire Color12V 15 80mA Red5V 18 300mA White/RedCurrent Draw of Sensors that Use This OutputFloScan Fuel Flow Sensor (100403-001): 50mAEI Fuel Flow Sensor (100403-003): 15mAUMA Differential Fuel Pressure: 10mARotax Honeywell Oil Pressure Sensor: 20mARotax Oil Pressure Sensor P/N 456180: 20mADynon Capacitance to Voltage Converter: 25mAKavlico pressure sensors: 5mA3 rd party trim and flaps position: 5mAManifold pressure sensor (100434-000): 10mATable 17- EMS Module Current Draw Limits for 5/12V LinesExample Engine Sensor and Transducer InstallationsThis section contains example engine sensor and transducer installations for popular engines.Each engine subsection listed on the following pages contains tables for each SV-EMS-220/221connector and suggests a way to connect that engine’s required sensors to the EMS module.These tables are based on the downloadable mapping and settings files available from Dynon’ssupport forums and may need to be modified based on your particular installation.Example Lycoming/Continental 4-cylinder Carbureted (SV-EMS-220)PinEMS 37-pin Harness Sensor (with Dynon part number ifWire Colorapplicable)1 Red Battery voltage (voltmeter input)2 Yellow or Unwired Not connected3 Black Ground4 Purple/Blue Elevator position potentiometer5 Black Ground6 White/Yellow Oil pressure (100411-002 or 101693-000)7 White/Brown Oil temperature (100409-000)8 Brown Fuel pressure (100411-000 or 101690-000)9 Brown/Blue Heated pitot status (contact input)10 Brown/Yellow Not connected11 Orange Not connected12 Yellow Not connected13 Black Ground14 Yellow Fuel flow (100403-003)15 Red Fuel flow power (100403-003)16 Black Ground17 Black Ground7-10 SkyView System Installation Guide - Revision O