SkyView System Installation Guide - Dynon Avionics

SV-EMS-220/221 Installation and ConfigurationFigure 27 is a pin insertion view (rear) of the male D25 on the Thermocouple Wire Harness.Figure 27– Thermocouple Wire Harness Male D25 Pin Insertion View (Rear)Sensors Powered by the SV-EMS-220/221Some sensors use a 5V (pin 18; white/red wire) or 12V (pin 15; red wire) power supply providedby the SV-EMS-220/221 module. These wires are designed to handle a limited amount ofcurrent. The typical Lycoming/Continental/Rotax/Jabiru installations as described in the rest ofthis chapter are designed to not exceed these current limitations. However, more complex andinstallations that differ significantly from these standard installations should be designed to notexceed the following current limitations:SkyView System Installation Guide - Revision O 7-9