SkyView System Installation Guide - Dynon Avionics

SV-EMS-220/221 Installation and ConfigurationTable 14–Sensor and Transducer Compatibility Level KeyFuture firmware updates may expand the scope of the compatibility levels listed in Table 14.The tables on the following pages specify the sensor and transducer types that are supportedby each pin on the male D37 and female D25 SV-EMS-220/221 connectors and the wire harnesswire colors. Note that the only purpose of the 25-pin SV-EMS-220/221 wire harness is forthermocouple connections. This guide generally refers to the different variations of this as thethermocouple harness. Each connector’s table is followed by a pin insertion view (rear)diagram.PinEMS 37-pinHarness WireFunctionSensor ConfigColor1 Red Voltmeter 1 (0 to 30 volts DC)2 Yellow or Unwired Voltmeter 2 (0 to 30 volts DC)3 Black Ground4 Purple/Blue General Purpose Input 1 A5 Black Ground6 White/Yellow General Purpose Input 11 B7 White/Brown General Purpose Input 12 A8 Brown Enhanced General Purpose Input 4 C9 Brown/Blue General Purpose Input 5 A10 Brown/Yellow General Purpose Input 6 A11 Orange General Purpose Input 7 A12 Yellow General Purpose Input 8 A13 Black Ground14 Yellow Fuel Flow Input 115 Red Auxiliary 12 volt DC Output16 Black Ground17 Black Ground18 White/Red Auxiliary 5 volt DC Output19 White/Black Fuel Flow Input 2 (Return)20 Orange/Brown General Purpose Input 9 A21 Orange/Blue General Purpose Input 10 A22 Purple/Yellow Enhanced General Purpose Input 2 C23 Purple/Green Enhanced General Purpose Input 3 C24 Orange/Green Amps + Amps Shunt25 Orange/Purple Amps - Amps Shunt26 Green/Red Manifold Pressure InputManifold Pressure(100434-000)7-6 SkyView System Installation Guide - Revision O