SkyView System Installation Guide - Dynon Avionics

SkyView Network ConnectionSV-EMS-220/221 Installation and ConfigurationConnect the EMS module to the SkyView network using the hardware mentioned in theSkyView System Construction Section or using equivalent hardware.If you have to install a connector on the end of a network cable, insert all pins into the D9connector. Reference Appendix C: Wiring and Electrical Connections for details on connectorpin-outs and wire colors.Remember to configure the network after connecting all modules to a display.SkyView EMS Sensor Definition and Configuration FilesThe SkyView EMS utilizes a file to define sensor behavior and a file to map those sensors to pinson the SV-EMS-220/221 and configure the sensors’ onscreen visual representations or widgets.The sensor definition file is preloaded onto all SkyView displays during manufacture and mayneed to be updated. The sensor mapping and configuration file is not preloaded onto displaysand must be downloaded and installed by the user. Reference the EMS Sensor Definitions,Mapping, and Settings Section for more information.Engine Sensor and Transducer PlanningIn order to save installers time, Dynon provides preconfigured sensor mapping andsettings files as well as premade engine sensor connection wire harnesses. Theseresources support many popular four and six-cylinder engine installations.Reference the Example Engine Sensor and Transducer Installations Section forexamples.Sensor mapping and settings files map SV-EMS-220/221 pins to enginetransducers and sensors and also configure onscreen engine gauges withappropriate graphical settings. Reference Dynon’s website atdownloads.dynonavionics.com for more information.The SV-EMS-220/221 is compatible with a wide range of sensors and transducers. ReferenceTable 56 on page 18-3 for a list of engine sensors and transducers that are known to becompatible with SkyView. Use the tools in this section as well as the worksheet on page 20-1when planning sensor and transducer installation.SV-EMS-220/221 Wire HarnessesEngine and environmental sensors and transducers are connected to the SV-EMS-220/221 viatwo connectors on the module: one male 37-pin D-sub connector (D37) and one female 25-pinD-sub connector (D25). Dynon offers premade wire harnesses which break out the pins onthese connectors and it is highly recommended that installers use these wire harnesses. Table13 lists these wire harnesses and their respective connections to the SV-EMS-220/221.SkyView System Installation Guide - Revision O 7-3