JAZZY 1143 Ultra - Pride Mobility Products

V. COMFORT ADJUSTMENTSMANDATORY! Read and understand this owner’smanual thoroughly before operating the power chair.WARNING! Failure to heed the following warningsmay cause the power chair to tip over.WARNING! Always fasten the positioning belt whenoperating the power elevating seat system.WARNING! Never raise the seat from its lowestposition on an inclined surface.WARNING! Never raise the seat from its lowestposition when operating your power chair on bumpyor uneven surfaces.WARNING! Never raise the seat while your powerchair is in the freewheel mode.WARNING! Maintain recommended tire pressure inthe drive wheel to maintain stability.Figure 25. Power Elevating Seat ActuatorNOTE: The power elevating seat option is equipped with a systemthat reduces the speed of the power chair by one-half when theseat is elevated more than 1-2 in (2.54-5.08 cm). Always check tobe sure this system is operating properly before using your powerchair.Power Elevating Seat OperationIf your power chair is equipped with a power elevating seat, you can change the seat height either through the controller orthrough a toggle switch mounted to one of the armrests.NOTE: For information on how to raise and lower your seat through the controller, contact your authorizedPride Provider.To operate the toggle switch:1. Push the toggle switch forward to raise the seat.2. Pull back on the toggle switch to lower the seat.The power elevating seat system has an upper and a lower limit of travel. Once the actuator reaches either one of theselimits, you should continue to hear and/or feel the actuator motor running. This is because there is a clutch mechanism thatallows the motor to continue running after the actuator has reached its limit. This clutch works at both the top and bottomextensions of the lift.WARNING! Do not allow the motor to run more than a few seconds after the mechanism reachesthe top or bottom limit.Jazzy 1143 Ultra www.pridemobility.com 33