Modular electrical linear drives OSP-E - parker-origa.com

Modular electrical linear drives OSP-E• Secure the drive end cap (2) with the four hex screws (11) at the aluminium profile (15).• Mount the end cap (15) with hex screws at the aluminium profile.• Tension the belt (8) in accordance with Chapter 7.3.4.• Push the outer band (8) through the carrier(6) and screw tight on both sides with the clamping pieces (3)at the aluminium profile.• Carefully mount and screw tight cover sheet (5) und cover with wiper (7).• Secure both covers with hex screws to the individual casings.• Mount again motor/drive unit as well as all other components attached to it (tightening torques clampinghub, refer to table for load values chapter 7.1 ff).• The components attached to the carrier are to be mounted again.Thread sizeTightening torquessocket head screwsThread sizeTightening torquescountersunk screwsM 31.2 ± 0.2 NmM 30,5 ± 0.1 NmM 43 ± 0.5 NmM 42,2 ± 0.1 NmM 55,5 ± 0.8 NmM 610 ± 1.5 NmOSP-E..BVVertical linear drive with toothed belt and integrated recirculating ball bearing guideIf the toothed belt must be replaced, ask the manufacturer of the drive for possible repair.20