Modular electrical linear drives OSP-E - parker-origa.com

Modular electrical linear drives OSP-E7.2 Structural arrangement and operating mode7.2.0 General arrangementThe linear drives are used in all those places where loads are to be transported and/or have to beprecision-positioned.With a combination of several linear drives, a wide-surface covering or room-orientated arrangementcan be realised.• On a slotted aluminium profile with dovetail grooves, on the ends, the end cap required for thedriving elements are mounted.• In this barrel profile, a driver is moved where supporting rings are attached to both ends. Theseprovide the lowest possible sliding friction.• The attachment of the load material is connected by way of threaded holes on the driver.• Dirt is prevented from getting into the aluminium profile by a outer band made of high qualitystainless steel.• An integrated permanent magnet at OSP-E..BHD and B is used for the purpose of position detection.A magnetic switch set is recommended for OSP-E..BV. The magnet must be fixed in the dovetailgroove.• The linear unit is attached by means of threaded holes on the end caps.7.2.1 OSP-E..BHDBHDII: Linear drive with toothed belt and integrated recirculating linear ball bearing guide.Design Features• Precision guide rail in steel.• Drive plate on guiding slide with integrated linear guidance system for ball bearings.• Toothed belt drive with integrated planetary gear (optional).• Motor can be mounted from below or above (optional).Threaded holes forsecuringToothed belt withsteel reinforcementDrive plate with integratedpermanentmagnet for positiondetectionThreaded holes- compatible with theProline-SeriesOuter band made ofstainless steelSetting belt tensionClamping shaft- for backlash-free coupling ofmotors and external gearsSlotted aluminiumprofile with integrateddovetail groovesGuiding slide with needlebearing rollersPrecision guide rail in steel7.2.2 OSP-E..BHDBHD: Linear drive with toothed belt and integrated roller guideDesign Features• Guide rail in the aluminium profile and driver on needle-bearings• Belt drive with integrated planetary gear (option).• Motor attachment from above or below (option) possibleThreaded holes forsecuringToothed belt withsteel reinforcementDrive plate with integratedpermanentmagnet for positiondetectionThreaded holes- compatible with theProline-SeriesOuter band made ofstainless steelSetting belt tensionClamping shaft- for backlash-free coupling ofmotors and external gearsSlotted aluminiumprofile with integrateddovetail groovesSlide with needle bearingrollersGuide rail with precision trackand calibrated bearing rails12