APC Symmetra PX User Manual - Gruber Power

More documents

Recommendations

Info

System Start-Up (if applicable)System start-up is included with your system. If you have to move your system to a new location andneed a new start-up, remove all power modules and follow the Total Power Off Procedure. Raise thestabilizing feet.Secure the UPS by Setting the Stabilizing FeetAfter the electrical wiring has been completed, secure the UPS in its final operating position. Use a13/14-mm wrench (shipped with UPS) to adjust all 4 stabilizing feet until pads make solid contactwith the floor.Level the UPS (Recommended)Adjust stabilizing feet to level from front to back and left to right.13/14-mm wrenchCAUTION!Do not move the UPS after the stabilizing feet have been lowered, or equipmentdamage may occur.28 Symmetra ® PX 10-80 kW, 208V – Operation & Maintenance Guide – 990-1430 REV01
?System Start-Up (if applicable)Power Module InstallationWARNING!Only APC-trained personnel familiar with the construction and operation of theequipment, and the electrical and mechanical hazards involved, may install and removesystem components.CAUTION!Before installing any modules in the UPS, ensure that the System Enable Switch is left in theSTAND-BY position (if not, see section on Total Power Off.At least 1 Battery Module (4 Battery Units) is required in the battery enclosure and theDC breaker to be on to start up the system. If using value line battery cabinets, batteryconfiguration will need to be entered manually through display,Installing9th8th7th6th5th4th3rd2nd1stStarting from thelowest available bay,remove as many blindplates as the number ofPower Modules to beinstalled. Install PowerModules and pushcompletely into theUPS.DOCUMENT STORAGESymmetra® PX10 - 40 kW, 200 VBasic Operation GuideSymmetra ® PX 10-80 kW, 208V – Operation & Maintenance Guide – 990-1430 REV01 29
Page 1: Symmetra PX UPS10-80 kW208 VOperati
Page 5 and 6: ContentsIMPORTANT SAFETY INSTRUCTIO
Page 7 and 8: IMPORTANT SAFETY INSTRUCTIONSSAVE T
Page 9 and 10: ?XR Co municationsBA TERY UNITIMPOR
Page 11 and 12: ?Overview of System ComponentsIntel
Page 13 and 14: OperationThe PowerView is the user
Page 15 and 16: OperationFunctional Schematic Dual
Page 17 and 18: OperationStatus FunctionsVerify gen
Page 19 and 20: OperationStatus Screen 6.Capacity:
Page 21 and 22: OperationAccessories screenControlS
Page 23 and 24: DisplayDisplay/Computer InterfaceXR
Page 25 and 26: ?XR Co municationsModule and Card R
Page 27 and 28: Module and Card ReplacementHow to r
Page 29 and 30: TroubleshootingThis section lists a
Page 31 and 32: TroubleshootingGeneral FaultDisplay
Page 33: TroubleshootingDisplay Message Mean
Page 37 and 38: ?Network Cable Installation (if req
Page 39 and 40: System Start-Up ProcedurePress the
Page 41 and 42: Life Support Policy/WarrantyFactory

APC Symmetra PX User Manual - Gruber Power

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?