warp/m service manual - ADB Lighting Technologies

Motorised Yoke8 WARP HEAD - Maintenance Sheet8.1 How to change the lamp assembly8.1.1 How to remove the old lamp AssemblyRequired Tool(s) Spare Part Code Preliminary readingWire CutterFlat Screw DriverScrew Driver PZ21001.61.000Chapter 7.1Chapter 7.3Before Change the lamp Assembly Unplug the WARP and remove the lamp:1. Unplugged the Motorised WARP and remove the Lamp2. Remove Left Arm Cover and Left Motor Wing Cover3. Unplug Lamp Cable from the Relay Board (see chapter 6,1)4. Cut All cable ties which fit the lamp wire from the PCB relay to the Tilt shaft5. Cut the cable near the 3 pts connector.6. Slide the old wire through the Tilt Shaft7. Open the Lamp Holder8. Keep the security cable on the peak and flat cylinder9. Remove it from the old lamp assembly (screw which fix the earth wire).1001.61.000 includes:• 1 complete lamp assembly (with grip on wire)• 4 M3 * 10 Taptite+ 1 M3*6• 2 Finger screws + springs• 10 cable ties• 1 x 3-pole connectorwww.adblighting.com Service Manual - page 73Issue 0.9