warp/m service manual - ADB Lighting Technologies

Motorised Yoke7.17 Remove WARP from the YOKERequired Tool(s) Spare Part Code Preliminary readingWARP KeyScrewdriver PZ2AMP Pin CrimpAMP Pin Extract Tool1001.65.880Chapter 7.1Chapter 7.2Chapter 6.11. Switch OFF and Unplug the WARP2. Open Arms cover and Disconnect lamp cable into the left arm.3. Use the special tool to extract pin from the AMP Connector, if not cut the cable4. Remove Motor Wing Cover (see chapter 7.2)5. Unplug and remove all Cables from Motor Wing through Tilt shaft (Motors, IR Sensor andXLR 4)6. Loosen Nut Right and Left between Arms and Motor Wing7. Slide the WARP through the Motor Wing Profile and pass lamp cable through the Tilt Shaft.Notice:• If you haven’t got a Pin Extract Tool, you can orderspare part 1001.65.880, which provides you newconnector and crimp pin. So you can cut wire nearthe existing one and replace it to re-assemble theWARP.Direction of Arrow = tountighten1001.65.8801001.65.880 includes:• 4 Pins• 1 Connector• 5 cable ties• 40 Screws M4*12 ZN• Thermo shrink sleeve• 4 cable tiesService Manual - page 54Issue 0.9www.adblighting.com