warp/m service manual - ADB Lighting Technologies
warp/m service manual - ADB Lighting Technologies
warp/m service manual - ADB Lighting Technologies
- No tags were found...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Motorised Yoke7.15 Replace Coarse TILT AMR SensorRequired Tool(s) Spare Part Code Preliminary readingScrewdriver PZ2Wire Cutter1001.65.230Chapter 7.1Chapter 7.7Chapter 6.11001.65.230 includes:1. Switch OFF and Unplug the WARP• 1 Sensor cable• 3 Screws M3*102. Remove Right Board (see chapter 7.7)• 3 Washers + 3 nuts3. Cut The cable tie and Disconnect Coarse Tilt sensor wire • 2 cable ties4. Remove the 4 taptite screws on the two sides of the arm.5. Slide down the Sensor Plate until access all screws of the AMR Sensor6. Replace the Magnetic Sensor using new screws2Important:• The first time you replace Coarse Tilt AMRSENSOR, you have to replace all taptitescrews By TCBC M4x8 ZN DIN 7985-Z.• When you re-start the WARP you have to recalibratePAN AXIS.• This can be started from web page or desk orlocal display.1001.65.2302431Note:• Distance between sensor andmagnet should be around 1 mm• You have small windows on thearm side to inspect the sensorpositionService Manual - page 52Issue 0.9www.adblighting.com