warp/m service manual - ADB Lighting Technologies

Motorised Yoke7.13 Replace Coarse PAN AMR SensorRequired Tool(s) Spare Part Code Preliminary readingScrewdriver PZ2 1001.65.230Chapter 7.1Chapter 6.11. Switch OFF and Unplug the WARP2. Disconnect sensor wire3. Remove the 2 Taptite screws4. Replace the Sensor Magnetic using new screws1001.65.230 includes:• 1 Sensor cable• 3 Screws M3*10• 3 Washers + 3 nuts• 2 cable tiesImportant:• The first time you replace AMR SENSOR, youhave to replace all taptite screws By TCBC M4x8ZN DIN 7985-Z.• When you re-start the WARP you have to recalibratePAN AXIS.• This can be started from web page, desk or localdisplay.1001.65.230Note:Distance between sensorand magnet should bearound 1 mm.Service Manual - page 50Issue 0.9www.adblighting.com