warp/m service manual - ADB Lighting Technologies

Technical Description6.2.1 24 V Power Supply6.2.1.1 DescriptionSPARE PART CODE 1001.65.010LOCATIONTOP BOXLINKSIn: Mains VoltageOut: Top BoardThe WARP/M is powered with 198 - 264 V AC, +/- 50/60 Hz (optional: universal power supply90 – 264 V, +/- 50/60 Hz). The connector is Neutrix PowerCon locking.The WARP/M is protected with a fuse of 6.3 A 250V SPT 5 x 20 mm.The lamp power is coming from an external dimmer.Power SupplyFuseLamp Supply6.2.1.2 How to know that the 24 V Power Supply present.It the “power” LED is on at power up of the WARP/M the 24 V supply is present. If the power LED isoff the 24 V power supply is not available. (refer to chapter 7.4.)For the early production units (production batch 1 to 10) the LED will only light up after the booting ofthe WARP/M (+/- 1 min). A quick way to check if the 24 V power supply is present is trying to movethe yoke just after power on. If Pan & Tilt Motors give resistance, the 24 V is present; if not, controlthe supply (refer to chapter 7.4.).Service Manual - page 22Issue 0.9www.adblighting.com