warp/m service manual - ADB Lighting Technologies

Trouble Shooting5.5 Problems with accessoriesTrouble/Symptom Origin SolutionToo much dust or oil (from Clean all IR sensors (right and left) withsmoke machine)air cleaner or alcoholNOCalibration on one Accessoryalways failsRight or Left IR sensor isdisconnectedRight or Left IR sensor cableis damagedNOControl connection and replace cable ifneededAccessory IR Sensor isdamagedBad CalibrationReplace Right or Left IR sensor (seechapter 7.25)Calibrate the failed AccessoryNODusty sensorNOClean all IR SensorOne Accessory has alwaysbad reset (but no errormessage on display)Index on the ring is erasedNOThe motor wing is not wellplaced (IR sensor not in frontof ring Index)Use special silvered paint and a smallbrush to paint the indexPlace the motor correctly (see chapter7.22.2)NOMotor of the failed Accessoryis mechanically forced (noisesin motor gear, motor slip orskid)Place correctly the corner plate behindmotors: small mechanical clearancebehind all 3 motors (see Chapter 7.28)Service Manual - page 18Issue 0.9www.adblighting.com