Manual Ossa Explorer - Ossa Canada

More documents

Recommendations

Info

Torque wrenches These grids show the pressure that should be used to tighten parts. CHASSIS ENGINE 48 User manual Part N-mN Part -m Front wheel axle 40 - 50 Handles Handlebar Front wing bridge section Break pedal Rear wheel axle 70 - 80 40 - 50 40 - 50 40 - 50 18 - 25 7 - 10 7 - 10 7 - 10 27 - 32 18 - 25 80 - 90 27 - 32 27 - 32 27 - 32 18 - 25 7 - 10 Sparkplug Water separator Ignition cover Engine drain plug Kick-start pedal screw Transmission pedal screw Cylinder block screws Cylinder nuts 11 7 - 8 7 - 8 25 7 - 8 3 - 4 7 - 8 7 - 8 7 - 8 40 10 7 - 8 12 12 - 13 7 - 8 8 - 9 25
Storage If the motorcycle is to be stored for a long period of time, the following procedure should be followed to ensure that it is stored correctly. - Clean the motorcycle as much as possible because dirt can cause the deterioration of components. -Turn on the engine for a few minutes to warm up the transmission fluid and then drain. (see section on draining fluid). -Fill up with new transmission fluid. -Empty the fuel tank (petrol degrades over time). -Lubricate the chain and all wires. -Apply oil to non-painted metal surfaces to prevent rust. Avoid putting oil on the brakes and rubber parts. -Wrap the outside of the exhaust pipe in a plastic bag to prevent rust. -Position the motorcycle so that the wheels don’t touch the ground to prevent possible tyre deformation. If this is not possible, cardboard can be placed underneath the wheels. -Place a cover over the motorcycle such as canvas, plastic or material. This will protect the motorcycle from dust and other external factors. Avoid storing the motorcycle outside, or in direct sunlight. Starting the motorcycle again Storage To start up the motorcycle after a period of inactivity, the following procedure should be followed: -Remove the plastic covers that were placed over the motorcycle before storing, including the exhaust pipe and those parts that had special protection. -Tighten the sparkplug. -Fill up the fuel tank with new petrol. -Carry out general lubrication. -Check tyre pressure. -Leave the engine running for some minutes to warm up the engine oil. User manual 49
Page 1 and 2: User manual 2012
Page 3 and 4: We at OSSA Motor would like to than
Page 5 and 6: Both your safety and the safety of
Page 7 and 8: Introduction 3 Important warning 4
Page 9 and 10: WEIGHTS AND MEASUREMENTS Wheelbase
Page 11 and 12: Section 1 - Components User manual
Page 13 and 14: 15 Rear break caliper and anti-thef
Page 15 and 16: The OSSA Explorer multi-function bo
Page 17 and 18: Functions RPM: Bar Bar graph tachom
Page 19 and 20: Time adjuster Set the time by press
Page 21 and 22: Dangerous turn rate selector When t
Page 23 and 24: Control Pad The control pad is loca
Page 25 and 26: In order to access some parts of th
Page 27 and 28: Before starting the motorcycle, you
Page 29 and 30: In order to access some parts of th
Page 31 and 32: Section 2 - Maintenance and basic o
Page 33 and 34: Rear shock absorber ChassisE ach us
Page 35 and 36: Check the condition of the motorcyc
Page 37 and 38: Simplified diagram if the injection
Page 39 and 40: The radiator contains the engine co
Page 41 and 42: The transmission chain transmits th
Page 43 and 44: Chain drive The chain drive should
Page 45 and 46: Pressure and condition To ensure th
Page 47: The brakes permit precise and contr
Page 51 and 52: PROBLEM POSSIBLE CAUSE POSSIBLE SOL
Page 53 and 54: PROBLEM POSSIBLE CAUSE POSSIBLE SOL
Page 55 and 56: Standardisation components User man
Page 57 and 58: 1 11 8 17 16 1.Front headlight 2.Fr
Page 59 and 60: Manufacturer’s plate Serial numbe
Page 61 and 62: Warranty User manual 61
Page 63 and 64: Warranty The repair is disproportio
Page 65 and 66: EXCEPTIONS TO THE WARRANTY The OSSA
Page 67 and 68: MAINTENANCE AND SERVICE Warranty It
Page 69 and 70: We recommend that you stay in conta

Manual Ossa Explorer - Ossa Canada

Create successful ePaper yourself

Delete template?

Save as template?