Quick Reference for End-Users Lambda Transmitter LT2 ... - lamtec

9 Faults / Warnings9.3 Resetting Faults / Warnings7 8 9 10 11 12 Warning No.:* Only relevant in conjunction with an integrated O 2 control system. Without an integrated O 2 control system the dynamics test should remain switched off parameter1330 "0”.222324252627Analogue input 4: input value toolarge / smallConfiguration error analogueoutputService warning 1Service warning 2*No LS2 probe dynamics*Dynamic test triggered• Via (optional) display and operating unit, via "diag”, menu-driven• Via service and diagnostic software, via "status”, menu-driven• Via digital inputs - input 1• By pressing the T2 multifunction key (for longer than 3 seconds per fault).If several faults are present simultaneously, the multifunction key must be pressed severaltimes.While pressing the key [diag] the display switches to warnings and faults. You can select thesingle warnings, faults or limit values with the cursor (up/down).NOTICE!Limit values are displayed only if they are activated in parameters 930/940/950/960 (Serviceebene).NOTICE!You can’t reset all warnings or faults by quitting them. If necessary, you have to eliminate thecause of the warning/fault.44