Alexandria X-2 Series 2 - Wilson Audio

S e c t i o n 4 . 8 – E x t e n s i o n S p i k e sSection 4.8 – Extension SpikesPlace one end of the expansion spike sub-assembliesinto the last hole of the spiketrack. Expand the sub-assembly until the upper end comes into contact with the dimplein the middle of the brass spike pad found on the underside of the wing braces. Use boxend wrenches (included) to snug the expansion spikes securely (see Figure 22).Section 4.9 – Installing the Back CoversAttach the cover over theresistor plate. The cover attachesusing the same stainlesssteel pin system as the grills(see Figure 23).Note: The rear resistor coverfeatures a glass insert. Takecare when installing or storingthe cover to avoid breakingthe glass.Attach the top cover overthe propagation delay hardware.Section 4.10 – ResistorsBy removing the backcover of your Alexandrias, youmay gain access to the resistorplate (see Figure 23). These resistorsserve several functions.Note: Only Wilson Audioreplacement resistors shouldbe used in your Alexandrias.Figure 24 - Resistor ChartWilson Audio Specialties63