Alexandria X-2 Series 2 - Wilson Audio

A l e x a n d r i a X - 2 S e r i e s 2 O w n e r ’ s M a n u a l• 8 sets of assembled spikes• The Wilson Audio Jack• The jack socket wrench• Swivel caster wrenchInstallation Procedure• Lock the rear casters to prevent the Alexandria from moving.• Slide the Wilson Audio Jack under the front of the Alexandria, centered betweenthe casters, so that the jack’s lift bolt is exposed. Place the lift plateso it is positioned about an inch behind the front facade of the Alexandriawoofer enclosure (see Figure 21).Note: An assistant should stand to the rear of the Alexandria to steady it.• Attach the wrench to the lift bolt and begin to slowly raise the front of theAlexandria by turning the bolt clockwise (see Figure 21).• After the front of the Alexandria is high enough (you will need approximatelyone and half inches of clearance beneath the caster), use the swivelcaster wrench to loosen the casters. Remove the casters.• Insert and screw-in the finished spike assembly. Hand tighten only!Note: Be very careful NOT TO CROSS THREAD the spikes. The base of the Alexandriasis made of “X” material and is prone to cross threading.Note: The spike will go into a different hole than the caster.• With one person stabilizing the Alexandria, lower the Alexandria by turningthe jack counterclockwise. Note that the Alexandria will now sit lowerin the front as the spike assembly is shorter than the caster. Use caution.60Wilson Audio Specialties