Alexandria X-2 Series 2 - Wilson Audio

More documents

Recommendations

Info

A l e x a n d r i a X - 2 S e r i e s 2 O w n e r ’ s M a n u a lSpike Assembly• Remove the mechanicaldiodes and moveSetscrewthe nut to about twoMechanical Diodethreads from thepoint. This will allowAllen Key Endforgreater movementwhen levelingthe loudspeaker system.3/8” NutSpike• Screw the spikes intothe diode until theFigure 20 - Alexandria Spike and Diode Assemblynut is against thediode. Be careful that the nut does not turn while inserting and threadingspikes into the diode.Note: Do not tighten these assembled spikes. You will need to unscrew themwhen you level the Alexendrias.• Place the set screw into the other end of the diode with the Allen head towardthe spike. This will ensure that if for any reason you have to removeyour Alexandria spikes, you will be able to withdraw the set screw safelyusing the supplied Allen wrench. Screw the set screw into the diode untilit meets the spike (see Figure 20).• Place the assemblies out of the traffic pattern until they are needed duringthe installation.58Wilson Audio Specialties
Section 4.7 – Using the Lift to Install SpikesS e c t i o n 4 . 7 – U s i n g t h e L i f t t o I n s t a l l S p i k e sMaterials RequiredNote: This is a two person job. Do not attempt this by yourself. The Alexandrias weighover 700 LBS and may seriously injure someone if tipped over.Figure 21 - Installing the spikes using the Wilson Audio JackWilson Audio Specialties59
Page 7 and 8: Wilson Audio Specialties7
Page 9: Section 1 - Introduction
Page 12 and 13: A l e x a n d r i a X - 2 S e r i e
Page 14: A l e x a n d r i a X - 2 S e r i e
Page 17 and 18: Section 2 - In Your Room
Page 19: S e c t i o n 2 . 1 - R o o m A c o
Page 32 and 33: Wilson Audio Specialties
Page 47: S e c t i o n 4 . 1 - I n i t i a l
Page 80 and 81: 80Wilson Audio Specialties
Page 98 and 99: Wilson Audio Specialties

Alexandria X-2 Series 2 - Wilson Audio

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?