Alexandria X-2 Series 2 - Wilson Audio

1. Cut the bands on the crate.S e c t i o n 3 . 1 – U n c r a t i n g t h e A l e x a n d r i a2. Remove all the screws from thetop and sides of the crate.3. Pull the top of the crate off,and pull the sides of the crateapart.4. Because the wing array is extremelyheavy, use two strongpeople to carefully lift thewing array out of the crate.Upper Midrange Module (UMRM)5. Locate the serial plate on theunderside of the lower horizontalsupport. Place thewings on the floor near thewoofer modules, matched tothe woofer module with thesame serial number.High Frequency Module (HFM)6. Remove the empty shippingcrates from the room.Uncrating the Upper Array Modules1. Locate the two crates labeled“Upper Modules.” Removethe three upper modules,from each crate (see Figure7). It is very important to ensurethat each of the modulesare matched to one anotherby serial number. The serialtags are located on the un-Lower Midrange Module (LMRM)Figure 7 - Uncrate Upper ModulesWilson Audio Specialties37