AADvance Safety Manual - Tuv-fs.com

Chapter 5 AADvance Functional Safety SystemImplementationEnvironmental RequirementsThe system installation environment presents a potential source of commoncause failure. It is necessary to ensure that the equipment is suitable for the intendedenvironment. Alternatively, methods of maintaining the equipment's environmentalconditions within its capabilities should be provided.The system must be installed in an IP54 standard cabinet if the environment isdesignated Pollution Degree 2 ((IEC 60950).Pollution Degree 2 is an environment classification according to the amount of drypollution and condensation present. Generally normally only non-conductive pollutionoccurs; Temporary conductivity cause by condensation is to be expected. Typically thistype of environment is found in Laboratories, test station and office environmentsController Environmental SpecificationsThe following environmental specification applies to all modules in the 9000 seriesrange.Table 13:Environmental SpecificationAttributeTemperatureOperatingStorage and TransportHumidityOperatingStorage and TransportVibrationFunctional StressContinuousOccasionalWithstandAccelerationEnduranceAccelerationShockAltitudeValue–20°C to 70°C (–4°F to 158°F)–40°C to 70°C (–40°F to 158°F)10% to 95% RH, non-condensing10% to 95% RH, non-condensing5Hz to 9Hz1.7mm amplitude3.5mm amplitude10Hz to 150Hz0.1g in 3 axes10Hz to 150Hz0.5g in 3 axes15g peak, 11ms duration, ½ sineDocument number 553630 Issue 7: February 2010 5-33