AADvance Safety Manual - Tuv-fs.com
AADvance Safety Manual - Tuv-fs.com
AADvance Safety Manual - Tuv-fs.com
- No tags were found...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Chapter 5 <strong>AADvance</strong> Functional <strong>Safety</strong> SystemImplementation if the mode of operation is configured to accept a confirmation alarm signal fromthe same fire detector, this shall not be inhibited for more than 4 min following thereceipt of the first alarm signal.Type C dependency (option with requirement)Following the receipt of a fire alarm signal from a fire detector or a manual call point,the CIE shall enter the fire alarm condition, but may have provision to inhibit theactivation of outputs until a second alarm signal is received from another fire detectoror manual call point, which may be the same or another zone. In this case it shall bepossible to configure the mode of operation at access level 3 to apply individually toeach of the following (where provided): output to fire alarm devices output to fire alarm routing equipment output to fire protection equipmentField ConfigurationsThe following are re<strong>com</strong>mended field loop circuits for line monitoring anddigital/analogue inputs.Line MoitoringThis section provides re<strong>com</strong>mended line monitoring circuits and resistor values. Youcan set-up line monitoring on the following modules: 9401 and 9402 Digital Input Modules 9431 and 9432 Analogue Input ModulesNote: You must ensure that there is no crossover between channels.Document number 553630 Issue 7: February 2010 5-11